APC Folding Propeller Hub 35mm LPFH2

APC Folding Propeller Hub 35mm LPFH2

This is the 35mm Folding Propeller Hub for a 30mm Spinner from Advanced Precision Composites. For use on Electric powered aircraft only (not for gas engines).

Features

• APC Folding Propeller Hub 35mm LPFH2

• Two-piece, gray composite propeller hub that goes on each side of the folding propeller blades to hold them in place (blades are not included, see REQUIRES)

• Hub has molded nut insets for easy tightening

• Comes in a bag attached to a header card

Specifications

• Overall Length: 48mm

• Length between blade mounting centers: 35mm

• Inner mounting diameter: 8mm

Contents

• One composite propeller hub, Two 3x10mm cap head screws, Two 3mm nuts, Two 3mm washers

Requirements

• Propeller blade sets (use APCQ4305 through APCQ4364)

• 2.5mm hex wrench (GPMR8012) to tighten cap head screws

• Hand and eye protection when operating propeller

Comments

• See propeller blades for assembly instructions.

• Sailplanes have no landing gear, and therefore would break a rigid propeller when the plane came in for a landing. The folding propeller folds back upon landing.

• The use of this hub will shorten the overall diameter of the prop by 10mm from the manufacturer's length listing