DuraTrax G-27CX SG Crankshaft w/Pull Start DTXG0256

DuraTrax G-27CX SG Crankshaft w/Pull Start DTXG0256

This is the DuraTrax/SuperTigre G-27CX Pull Start Racing Engine for the DuraTrax Raze, DTXD76**.

Features

• DuraTrax G-27CX SG Crankshaft w/Pull Start DTXG0256

• ABC cylinder construction-"A"luminum piston,"B"rass cylinder liner that is "C"hrome plated

• Dual ball bearing-supported crankshaft

• Dual needle Slide Valve Carburetor

• Machined aluminum blue cylinder head

• Rear exhaust

• SG (pilot) Crankshaft

• Three year limited warranty

Specifications

• Displacement: .27 cu in (4.4cc)

• Bore: .72" (18.2mm)

• Stroke: .67" (17mm)

• Output: 2.5 hp @ 30,000 rpm

• Practical RPM Range: 3,000-35,000

• Weight: 14.1oz (400g)

• Distance Between Mounting Holes Same Side: .83" (21mm)

• Distance Between Mounting Holes Opposite Side: 1.4" (37mm)

• Height from Bottom of Mounting Tabs/Top of Cylinder Head: 3.6" (92mm)

• Height from Bottom of Crankcase to Top of Cylinder Head: 4.2" (107mm)

• Width at Mounting Tabs: 1.8" (46mm)

• Distance from Pull Start to Front Bearing: 3.3" (84.5mm)

• Distance from Pull Start to End of Crankshaft: 3.9" (99mm)

• Diameter of Exhaust Opening: .59" (15mm)

• Diameter of Carburetor Opening: .56" (14.2mm)

• Factory Needle Settings:

• High Speed Needle: 4.5 turns OUT from closed

• Low Speed Needle: 12.5 turns OUT from closed

Contents

• DuraTrax/SuperTigre G-27CX Pull Start Racing Engine with glow plug

Requirements

• Fuel: Car fuel blend with 20% nitromethane content (ODOP3520)

• Glow starter, plug wrench and track equipment