Duratrax Photon Speed 2 Motor w/Connectors Evader EXT DTXC3301
This is the Photon Speed 2 Motor (20 turn, single wind) from Duratrax. This is the stock motor found on the Duratrax Evader EXT.
Features
Duratrax Photon Speed 2 Motor w/Connectors Evader EXT DTXC3301
Great for monster trucks
20 Turn
Bushing motor
Standard (not laydown) brushes
Non-adjustable timing
Specifications
Turns: 20
Winds: 1(single_wire)
Stock for 7.2-8.4 volt battery
Uses oilless type brushes
Shaft Diameter: 3mm
Shaft Length: 12mm
Overall Length: 68mm
Outside Diameter: 36mm
Contents
One motor
Two pre-installed capacitors
Pre installed bullet-type motor leads
Requirements
Two 3mm mounting screws
Bullet-type leads for speed control, if needed (TRIC5500)
Comments
BREAK-IN
For proper break-in, use a 3-5volt power source, run the motor with no load. The contact patch should take up at least half of each brush's surface. Do NOT use more than 5volt power, as the commutator may be damaged.
MAINTENANCE:
Brushes wear out! Continuing to use worn brushes will ruin the commutator and interfere with its ability to conduct electricity (the worn part of the commutator will appear dark). Overhaul your electric motor often. Inspect the brushes at the first sign of wear usually after 5 to 10 Nicd packs are run). Inspect and clean the Brush Holder frequently. The contact between the brush and the commutator becomes bad if the brush holder is filled with dust or dirt. If brushes show sign wear, replace the pair.
"What else can I say, but this Magic Cars Hummer is awesome. Bought it for my 1 year old son and he loves it." ... read more