EMS EMO1012 Opto-Isolated E-Switch JR/Hitec/Z

EMS EMO1012 Opto-Isolated E-Switch JR/Hitec/Z

This is the Opto-Isolated E-Switch with Hitec/JR/Z connector.

This is a Solid-State Replacement for a Servo and Switch combined.

Features

• EMS EMO1012 Opto-Isolated E-Switch JR/Hitec/Z

• Adjustable ON point, reversing switch and LED indicator.

• Optically isolated for no radio noise problems.

• Use as "Old Timer" ignition cut-off, Glo driver switch, Smoke pump control, or an On-Board Starter.

• High Current Switching Capability

• Selectable Stick Direction of ON/OFF

• Positive Switching Point with Hysteresis for No Switch Center

• Load Power Automatically Turns off when Receiver Power is Turned OFF.

• Works with AM, FM, and PCM radios.

Specifications

• Length: 1.47" (37.5mm)

• Width: 1.56" (39.6mm)

• Height: .75" (19.1mm)

• Weight: .7 oz (20g)

Contents

• One Opto-Isolated E-Switch with Hitec/JR/Z connector.

• One 6-1/2" piece of solder.

Requirements

• Soldering wires with included instructions.