Futaba 6EX 6 Channel 2.4GHz Air R617FS 4-S3004 FUTK6901

Futaba 6EX Transmitter with the 2.4GHz FASST system, R617FS 6-ch Receiver and four S3004 Ball Bearing Servos. Full Range System-Ideal For All Types of R/C Aircraft Including Park Flyers.

Features

• Futaba 6EX 6 Channel 2.4GHz Air R617FS 4-S3004 FUTK6901

• Futaba's FASST (Futaba Advanced Spread Spectrum Technology) shifts very quickly virtually eliminating signal conficts and
  interruptions unlike other 2.4GHz systems that only stay on one or two frequencies

• R617FS high sensitivity receiver weighs only 0.25oz (7g) without case yet is a full range system for all aircraft from giant scale to Park Flyer applications-no need to buy separate receiver for specific aircraft, rubber grommets installed where antennas exit to eliminate stress and fraying of the wires

• Dual antenna diversity enables FASST system to automatically and seamlessly select the best reception between the two antennas built into the receiver ensuring that the aircraft stays under constant control of transmitter regardless of altitude

• Pre-Vision Packet Screening technology scans incoming data for potential problems and applies sophisticated error correction techniques for solid impenetrable link with model

• Easy Link system features a unique ID code in the transmitter that links to the receiver insuring that receiver only follows commands from this transmitter-with over 134 million possible codes there is no chance for a conflict

• No hassle Fail Safe programmed through transmitter-no complicated set-up steps or binding plugs

• When performing a ground check, the Power Down function allows modeler to reduce power from up to 50+ paces away-like retracting the antenna on a conventional transmitter

• Purpose built custom IC chips for key functions; no off-the-shelf IC chips

• Low battery and mixing alarms

• One year limited warranty

  Standard Programming Features

• Trainer function-transmitter can be master or student, compatible with other Futaba systems

• Six model memory

• Servo reversing

• End point adjustment

• Airplane or heli programming

• Dual Rate /Exponential for ailerons, rudder and elevator

• Fail Safe-safety throttle setting in case of transmitter signal loss

• Battery Fail Safe-safety throttle setting in case of signal loss

• Throttle Fail Safe

• Stick Mode-Choose from Mode 1-Mode-4

• Changeable Throttle Stick-ratchet for airplanes or smooth for helis

• Adjustable Stick Length

  Airplane Features

• Programmable Mixing (1 & 2) any two channels can be combined

• Pre-Programmed Throttle Cut for safely shutting engine OFF

• Wing mixing for flaperon, flap trim, V-tail and elevon

  Helicopter Functions

• Three swashplate types

• Five-Point Normal and Idle Up Throttle/Pitch Curves

• Revo, Gyro and Swash to Throttle mixing

• Swash AFR Adjustable Function Rate for use w/ 3S or 3E swash types

  Specifications: Futaba 6EX Transmitter

• Power Supply: 9.6V

• Current Drain: 170mA

  Specifications: Futaba R617FS Receiver FUTL7627

• Size: 1.6 x 1.1 x .35" (40 x 27 x 9mm)

• Power Requirement: 4.8 - 6V

• Current Drain: 80mA (at no signal), 74 mA(w/ signal no servos on 4.8)

• Weight: 0.34oz (9.8g) with case, 0.25oz (7g) without case

  Specifications: Futaba S3004 Servo FUTM0004

• Speed: .23 sec/60� @ 4.8V

• .19 sec/60� @ 6.0V

• Torque: 44 oz-in (3.2 kg-cm) at 4.8V

• 57 oz-in (4.1 kg-cm) at 6.0V

• Length: 1.6" (41mm)

• Width: .8" (20mm)

• Height: 1.4" (36mm)

• Weight: 1.3 ounce (37.2 grams)

• Connector: "J" type with approx. 5" wire

Package Contents

• Futaba 6EX Transmitter   

• NT8F600B 9.6V 600mAh Transmitter Battery FUTM1440

• FBC-19B(4) Battery Charger FUTM1830

• Four S3004 Ball Bearing Servos, FUTM0004

• R617FS Receiver FUTL7637

• Switch Harness-J Style Connector FUTM4350

• Neck Strap