Great Planes C-12 Micro Brushed ESC w/BEC GPMM2015

Great Planes C-12 Micro Brushed ESC w/BEC GPMM2015

This is the C-12 Micro High Frequency Electronic Speed Control w/BEC. For small to medium size electric aircraft with 400 size or smaller Brushed Motors requiring 12A or less.

Features

• Great Planes C-12 Micro Brushed ESC w/BEC GPMM2015

• Extremely compact size to minimize weight and simplify installation

• Set battery type with included jumper

• "Safe-Start" system prevents accidental motor starts by disabling the motor circuitry until the throttle stick is moved to full throttle, then to the OFF position.

• Factory installed motor, radio and battery connectors

• Fully proportional forward only (no brake)

• Battery Eliminator Circuitry provides sufficient current for the receiver and three to four micro servos. The motor battery powers the receiver and servos, then when voltage is reduced to the appropriate level, the Low Voltage cut-off circuitry stops the motor while continuing to supply power to the receiver and servos.

• High frequency to optimize battery run-time and cool operation

• Brilliant Blue LED and audible tones for easy set-up

• Very smooth throttle response

• 180 day limited warranty

Specifications

• Length: .83" (21mm)

• Height .31" (8mm)

• Width: .43" (11mm)

• Weight: .28 ounce (8g) with wires

• Input: 6-8 NiCd/NiMH cells; 2-3 LiPo cells

• Max Rated Current: 12A continuous

• BEC Voltage: 5V/1A

• Low Voltage Cutoff: .80V per cell for NiCd/NiMH 2.75V per cell for LiPo

• Connectors: Receiver lead- Universal

• Battery lead- Deans 2R micro connector

• Motor connector- 2mm gold plated female bullet connectors

• Switching Frequency: 2.5kHz

• Motor Size: 400 or smaller Brushed only

Contents

• One C-12 Micro Electronic Speed Control with Deans polarized micro connector for battery, 2mm gold plated female bullet motor connectors and Universal receiver connector One instruction sheet

Requirements

• Attaching to motor and setting up speed control

• Battery pack

• Plug Universal plug into the throttle channel on the receiver

Comments

• Will handle 4 micro servos with proper cooling

• Do NOT use with Brushless motors