Hot Bodies 67800 1/8 D8T Nitro Truggy Kit
This is the 1/8 scale, glow powered, radio controlled, Hot Bodies off-road D8T Truggy Kit.
Features
Hot Bodies 67800 D8T Kit
Chassis: 0.16" (4mm) thick 7075 aluminum with 10� of kickup, composite chassis braces
Drive: Four wheel shaft drive
Fuel Tank: 5.1oz (150cc) plastic with flip top cap
Air Filter: Foam low profile design
Clutch: 3 shoe, carbon construction
Clutch Bell: 13 tooth steel
Transmission: Single speed
Ball Bearings: Full set
Shocks: Four oil-filled, 16mm Big Bore aluminum bodied
Main Gear: 50 tooth steel
Gearboxes: Sealed
Differentials: Planetary
Brakes: Dual fiber discs
Wheels: White plastic dish wheels, 3.7" (95mm) diameter, 2.3" (58mm) wide, 17mm hex
Body: Clear untrimmed polycarbonate truggy body
Bumpers: Front hardened plastic
Suspension: Captured hinge pin design, extra wide pivot block for optimized geometry
Caster: Adjustable, caster/toe-in refers to the angle of the front suspension when viewed from the side of the car in relation to the chassis
Camber: Adjustable, camber refers to the angle of the tops of the tires from vertical when viewed from front or behind vehicle
Steering: Bell crank type with servo saver
Warranty Period: Two year limited, valid only in the U.S. Canada, and South America
Specifications
Vehicle-
Length: 21" (530mm) from front bumper to end of rear wing
Width: 15.9" (405mm)
Weight: 9lbs (4082g) approximately
Wheelbase: 15-15.1" (380.5-383.5mm) wheels on-center front-to-rear
Gear Ratio: 4.3:1
Body-
Length: 18.2" (462mm)
Width: 7.4" (188mm) at middle section (widest point) 6.9" (175mm) ahead of front wheels (thinnest point)
Height: 4.1" (105mm)
Package Contents
1/8 scale Hot Bodies off-road Truggy Kit, foam air filter, body, wheels, rear wing, clutch bell, spur gear, instructions and decal sheet
Requirements
Radio: 2-Channel with 2 Servos (one high torque servo for steering)
Radio Batteries: (8) AA size
Receiver Pack: 6V hump
Engine: .21 cu in (3.4cc) rear exhaust
Exhaust: Tuned pipe
Engine Starter: Hand-held type with rubber adapter for vehicle use
Tires: 1/8 scale off-road truggy
Glow Starter: 1.2 volt
Paint: Polycarbonate safe for body
Misc. Items: Fuel bottle, building and track equipment
Fuel: 2-cycle glow fuel with 10%-15% nitromethane, 16% lubricant
Comments
For Replacement Ball Bearings use:
Qty. Size Location Qty. Bearing Set
2 6x10mm Steering 1 DTXC1561
6 8x16mm Diffs 3 DTXC1585
2 5x11mm Clutch 1 DTXC1547
4 8x14mm Front Hubs 2 DTXC1583
4 8x14mm Rear Hubs 2 DTXC1583
"What else can I say, but this Magic Cars Hummer is awesome. Bought it for my 1 year old son and he loves it." ... read more