HPI Nitro Star F4.6 w/Pullstart 1495
This is HPI's Nitro Star F4.6 .28 size Engine With Pullstarter. Can be installed in the HPI Savage X 4.6 Monster Truck, HPID67** for those who prefer an engine with a pull starter.
Features
HPI Nitro Star F4.6 w/Pullstart 1495
Composite construction slide valve, 7.5mm 3 needle carburetor, high speed needle, idle screw and low speed needle are set flush with the carburetor body for factory settings 8 port chrome plated brass sleeve
ABC cylinder construction, "A"luminum piston with a "B"rass cylinder that is "C"hrome plated
Purple anodized billet aluminum heat sink head
Round rear exhaust port
Cast aluminum crankcase with heatsink fins
Machined pilot shaft crankshaft with collet preinstalled
Knife-edge billet aluminum connecting rod with dual bushings.
High flow 2-stage air filter dramatically reduces intake restriction as it smoothes and straightens air flow
Two year limited warranty
Specifications
Height/bottom of Mounting Flanges/top of Cylinder Head: 4" (101mm)
Height/bottom of Crankcase/top of Cylinder Head: 4.5" (114mm)
Length from Pull Starter to Front Bearing: 3.3" (84.5mm)
Length from Pull Starter to end of Crankshaft: 4.6" (117mm)
Width at Mounting Flanges: 1.81" (45.9mm)
Mounting Hole Center Same Side: .82" (21mm)
Mounting Hole Center Opposite Side: 1.42" (36mm)
Bore: 18.68mm
Stroke: 16.6mm
Horsepower: 2.9 @ 32,000 RPM
Crankshaft diameter: 5mm (clutch bell area)
Crankshaft diameter: 6.7mm (threaded portion)
Displacement: 4.6cc (.28 ci)
Contents
Nitro Star .28 F4.6 glow engine
Glow Plug - HPI R5 cold plug (HPIG1504 for a replacement)
Dual Stage Air Filter (HPIC7198 for replacement)
Instructions and exploded views
Requirements
Glow Fuel: 20-25% nitro content
Glow starter
Tuned pipe
Manifold
?
"What else can I say, but this Magic Cars Hummer is awesome. Bought it for my 1 year old son and he loves it." ... read more