DLE Engine DLE-30cc Gas Engine Rear Carb

DLE Engine DLE-30cc Gas Engine Rear Carb

This is the DLE 30cc Gasoline Powered Engine with Electronic Ignition and Rear Mounted Carburetor.

This replaces the DLEG0030.

Features

• DLE Engine DLE-30cc Gas Engine Rear Carb

• Two sealed bearings on crankshaft-simple design for lighter weight

• Aluminum alloy crankcase

• Rear mounted pumper carburetor ensures easier installation and smooth idling and dependable fuel flow during flights

• Fully automatic electronic ignition

• Two year limited warranty through Hobby Services beginning at date of purchase

Specifications

• Output Power: 3.7 HP at 8,500 RPM

• Idle Speed: 1,600 RPM

• RPM Range: 1,600-8,500

• Static Thrust: 8.5kg Pulling Force/100 meters altitude 7.5kg Pulling Force/1,800 meters altitude

• Displacement: 1.86cu in (30.5cc)

• Bore: 1.42" (36mm)

• Stroke: 1.18" (30mm)

• Compression Ratio: 7.6:1

• Weight: Engine, 2lbs (910g)

•             Muffler, 2.1oz (60g)

•             Ignition, 4.2oz (120g)

• Gasoline/Oil Mixture: 30:1

• Gasoline Octane Rating: 87

• Recommended Propellers: 18x8 for break-in, 18x10, 19x8, 20x8

• Spark Plug: CM6

• Carburetor Adjustments;

• Low Speed Needle: 1.5 turns out as a starting point, adjust for a smooth idle and a reliable transition to high throttle

• High Speed Needle: 1.5-2 turns out from closed, adjust needle to peak RPM, if engine slows or dies at full throttle, the high-speed mixture is likely too lean

• Distance Between Mounting Hole Centers Same Side: 2.1" (54mm)

• Distance Between Mounting Hole Centers Opposite Side: 2.7" (70mm)

• Height from bottom/Crankcase to top of Cylinder Head: 5.4" (138mm)

• Width of Cylinder Head: 2.5" (65mm)

• Distance Between Muffler Mounting Hole Centers: 1.3" (34mm)

Contents

• Engine, spark plug, four standoffs, ignition, muffler, muffler gasket, two 5x20mm muffler bolts, four 5x60mm mounting bolts instruction manual

Requirements

• Gasoline with at least 87 octane rating

• 2-cycle oil, mix ratio for this engine is 30 parts gas to one part oil and must be followed exactly for warranty consideration and optimum performance

• 4.8 - 6V NiMH/NiCd, or 6.6V LiFe or 7.4V LiPo battery for ignition (separate receiver style pack can be used) (LiPo use requires voltage regulator)

• Propeller and field equipment

Comments

• To avoid permanent damage to the electronic ignition system, NEVER turn your DLE engine over with the system switched on and the plug not installed.

• *** A composite throttle arm lever has replaced the metal lever ***