Main Large Bearing for Most Largeframe Vintage Vespas

Main Large Bearing for Largeframe Vintage Vespas

This large crankshaft bearing is made for the clutch side of most largeframe vintage Vespas. On several models it also works as the flywheel side bearing, so it covers a wide range of uses. It installs in the same spot as the original part, making it a straightforward swap among vintage Vespa scooter parts. Keeping this component in good shape helps the engine run properly and last.

Application and Compatibility

This bearing suits a variety of vintage Vespa models, so you can count on it fitting your scooter correctly. On VNA, VNB, VBB, VBA, VLB, VLA, VBC, VNC, VB1, VS5, and VL1-VL3 models, you'll need two bearings, one for each side. For P-series scooters, use part 133068 on the flywheel side.

Replacement Considerations

When the engine is already apart for repairs, it's worth looking at the rear hub bearing too, which is part #90025. Doing both at once can save time and help the scooter run smoothly once it's back together.

Specifications

• Position: Clutch side
• Fits: Genuine Stella 2T crankcase, clutch side, largeframe vintage Vespas

Fitment

Fits:

• Genuine Stella 2T (clutch side, largeframe)
• Vespa VNA, VNB, VBB, VBA, VLB, VLA, VBC, VNC, VB1, VS5 and VL1-VL3 (flywheel side too, needs 2)

Where it goes: part #12 on the crankcase diagram for the Stella 2T.

Shop more: Vintage Vespa Parts · Scooter Bearings · Scooter Parts