OEM Genuine Venture 50 Speedometer Drive Gear for 12mm Front Hub

Speedometer Drive Gear for Genuine Venture 50

This OEM speedometer drive gear is made to suit the Genuine Venture 50 scooter, helping the speedometer show correct readings. It is meant to replace gears that have worn out or failed, which can make the needle jump around or stay at zero. Like other Genuine scooter parts, it drops into the existing assembly, so installation is simple and performance stays dependable.

Exact Fit

This drive gear is sized for the 12mm front axle on the Genuine Venture 50, so it lines up as intended. Compared with non-branded substitutes, it cuts down on vibration and passes the signal to the speedometer cable more accurately. It is a direct swap, so no alterations are needed before fitting it.

Build and Longevity

The gear is made from wear-resistant material that handles everyday riding. It copes well with heat, vibration, and debris from the road, and it tends to last longer than unbranded versions. That lasting quality helps the speedometer keep reading accurately over the long run.

Fitting Advice

Before fitting the new gear, wipe the axle clean and put a light coat of grease meant for wheel bearings onto the inner teeth. Doing this reduces early wear and keeps the speedometer needle moving smoothly. While the wheel is off, also check the speedometer cable for damage. Swapping the cable at the same time as the gear can head off future problems.

Specifications

• Material: Composite
• Size: 12mm Axle Diameter
• Position: Front Wheel (Right-Hand Side)
• Fits: Genuine Venture 50 front wheel with 12mm axle (right-hand side)

Compatibility

Fits:

• Genuine Venture 50 (12mm front axle, right-hand side)

Where it goes: part #4 on the front wheel assy diagram for the Venture 50.

Shop more: Genuine Scooter Parts · Scooter Speedometers & Gauges · Scooter Transmission & Final Drive · Scooter Parts