EMS EMO1020 Dual E-Switch Futaba J
This is a Dual E-Switch for Futaba Radios by EMS
Features
EMS EMO1020 Dual E-Switch Futaba J
Lightweight Design
Control Two Functions with one Radio Channel
Each Output is rated for 5 continuous amps and up to 30 volts
Each Output can be configured for Momentary of Latching Mode
Specifications
Length: 1.5"
Width: 1.5"
Height: 0.75"
Wire Length: 11"
Contents
One E-Switch Unit
One Length of Solder
One Instruction Sheet
Requirements
Soldering of Wires to Unit
Comments
Negative of battery gets soldered to two center hole on the board.
Positive wires from function (Motor, etc.) get soldered to the holes closest to the MOSFETs.
Momentary mode means function will be ON while the radio stick is away from center. When stick returns to center function will turn OFF.
Latching means function will turn ON and remain so when stick is moved from center. Function will turn OFF when stick is moved again in the same direction.
Unit is basically an ON/OFF switch that is controlled by the radio stick. It would be similar to having extra switches on the radio itself.
Unit is NOT proportional.
If either output of the Dual E-Switch is used to control a motor, install a diode (1N4001) between the motor and the terminals.
"What else can I say, but this Magic Cars Hummer is awesome. Bought it for my 1 year old son and he loves it." ... read more