Fuji Imvac BT-24EI 24cc/1.5CI Gas Engine

Fuji Imvac BT-24EI 24cc/1.5CI Gas Engine

This is the BT-24EI Gasoline Airplane Engine from Fuji Imvac.

Features

• Fuji Imvac BT-24EI 24cc/1.5CI Gas Engine

• Electronic ignition offers full 30� timing sweep for better idle and top end performance

• Dual ball bearings on both the crankshaft and connecting rod

• Easy straight-out throttle linkage

• Compact muffler fits into cowlings easier

• Walbro carburetor features easy-to-use butterfly choke valve

• THREE YEAR warranty

Specifications

• Displacement: 1.46 cid (24cc)

• Practical RPM: 1,200-11,000 RPM

• Output: 2.2 bhp @ 10,000 RPM

• Weight: 3.20 lbs (1,453 g) with muffler 2.95 lbs (1,342 g) without muffler

• Fuel ratio, gas/oil mix: 100-150:1, (1:50:1 for break-in)

• High Speed Needle Setting: Open � turn from closed, �� turn in Winter

• Low Speed Needle Setting: Open 1/3/8 turn from closed, �� turn in Winter) NOTE-It is not necessary to change needle settings if engine runs smoothly. Normally only the "H" needle will need adjustment from time to time and only a small amount.

• On-Center Mounting Holes, Side to Side: 2.7" (70mm)

• On-Center Mounting Holes, Top to Bottom: 3" (76mm)

• Engine Height, Including Spark Plug: 6.5" (165mm)

• Length from Muffler to Carb Opening: 5.75" (146mm)

• Length from Mounting Plate to Magneto Rotor: 4" (102mm)

• Length from Crankshaft to Magneto Rotor: 4.5" (114mm)

Contents

• One BT-24EI Gasoline Airplane Engine from Fuji Imvac with Champion RCJ6Y resistor spark plug, plug wrench, muffler, motor mount, instruction manual, prop flange with washer, prop bolt, friction ring, 4mm hex wrench and Electronic Ignition System

Requirements

• 2-cycle oil, FJIP9910

• Battery for ignition

• Engine ON/OFF switch

• Propeller: 16x8 (APCQ1608), 16x10 (APCQ1610) or 16x10 carbon prop

Comments

• Fuji Imvac is NOT related to the original Fuji engines sold by MECOA.