Futaba 12FGH 12-Channel 2.4GHz/R6014FS Rx Heli Mode 2 FUTK9276

This is the Futaba 12FGH Transmitter and R6014FS 14-ch Receiver with the 2.4GHz FASST system.

This version is Mode 2-Left Hand Throttle and Right Hand Elevator, USA Standard **For European Standard Mode 1-Right Hand Throttle and Left Hand Elevator** **order FUTK9278**

If your transmitter's region code is something other than the United States, the TM-14 Module sold in the United States is not compatible with this transmitter. As such, it is necessary to purchase the TM-14 module which matches the region code of the transmitter.

When you improve upon all of the best that Futaba 2048 technology has to offer,you have the 12FG-one serious system for discerning R/C pilots. From the state-of-the-art receiver to the capacity to store memory for a whopping 1,882 models, the 12FG has the features and functions to position itself far above the competition. And because it's from Futaba, you can fly with confidence, knowing that the industry's finest research and development is behind you.

Contains software for airplanes, helicopters and gliders. This is the helicopter version which will default to helicopter settings, with mode 2 stick operation and does not have a ratcheted throttle.

For the latest information about the 12MZ visit the manufacturer's web page at www.2.4gigahertz.com. Some of the system's most impressive highlights include the following:

?

Features

• Futaba's FASST (Futaba Advanced Spread Spectrum Technology) shifts very quickly virtually eliminating signal conflicts and
  interruptions unlike other 2.4GHz systems that only stay on one or two frequencies

• Dual antenna diversity enables FASST system to automatically and seamlessly select the best reception between the two antennas
  built into the receiver ensuring that the aircraft stays under constant control of transmitter regardless of altitude

• Pre-Vision Packet Screening technology scans incoming data for potential problems and applies sophisticated error correction techniques for solid impenetrable link with model

• Easy Link system features a unique ID code in the transmitter that links to the receiver insuring that receiver only follows commands
  from this transmitter-with over 134 million possible codes there is no chance for a conflict

• No hassle Fail Safe programmed through transmitter-no complicated set-up steps or binding plugs

• When performing a ground check, the Power Down function allows modeler to reduce power from up to 50+ paces away-like retracting
  the antenna on a conventional transmitter

• Purpose built custom IC chips for key functions; no off-the-shelf IC chips

• Digital trims on all 4 main channels

• Ergonomic rubber grips

• Quad-bearing gimbals

• Ultra-precise tuning in .5% increments

• 255X196 LCD scren with adjustable contrast

• One year limited warranty

  Programming Features

• Thirty model memory

• Programming for airplane, glider and helicopter models

• Supports 13 wing types, 3 tail types and 8 heli swash tupes

• Eight flight conditions

• Variable dual rates

• Servo grouping for servo synchronization

• Newly designed "joystick" button and Dial-N-Key editing for easier menu navigating

• Stick Mode-Choose from Mode 1-Mode-4

• Twenty-seven pre-programmed mixes, with built-in shortcuts

• Three swashplate types

• Five-Point Normal and Idle Up Throttle/Pitch Curves

• Revo, Gyro and Swash to Throttle mixing

• Swash AFR Adjustable Function Rate for use w/ 3S or 3E swash types

Specifications

• Transmitter
  Power Supply: 7.2V

• Receiver
  Power Requirement: 4.8 - 6V

Package Contents

• Futaba 12FGH Transmitter

• 7.2V 1700mAh NiMH Transmitter Battery

• 1500mAh NiCd Receiver Battery

• R6014FS Receiver, FUTL7644

• Heavy-Duty Switch Harness

• Futaba Orange Transmitter Neck Strap

Comments

• This radio is available in other default modes, below are the three options: FUTK9275 Air Mode 2

• The only chargers that will work with the 12FG is FUTM1805 (which is included with the radio system OR FUTM4160 which will require charge leads FUTM4236.

• This system can also be operated on 72MHz or 50MHz by purchasing the Transmitter Antenna (FUTM5118), and the 72MHz Module (#HSP78899) or the 50MHz Module (#HSP79189)-both must be purchased through Hobby Services) and using a compatible receiver.