Hobbico Digital Voltmeter MkIII HCAP0356

Hobbico Digital Voltmeter MkIII HCAP0356

This is a Digital Voltmeter MkIII from Hobbico. Tests 4, 5 & 8 cell R/C batteries in a no-load or a simulated R/C load setting.

Features

• Hobbico Digital Voltmeter MkIII HCAP0356

• Custom designed LCD shows voltage in clear �" numerals, plus customized characters to easily determine the meter setting and condition of the battery under test. The LCD not only displays voltage, but voltage mode, "OK" and "RECHARGE". Test 5 cell packs, in addition to 4- and 8-cell batteries.

• Includes a common 9V battery, located inside an easy-to-access compartment.

• Built-in simulated R/C load of 250mA for each setting

• Includes two input controls: a small pushbutton on the left side of the case, and a 3-position slide switch on the face of the meter.

• Switch load OFF and use it as a true Digital Voltmeter

• Measures DC voltage up to 19.99V, making it versatile enough for any

• DC battery - transmitter/receiver packs, starter batteries, and glow starter batteries.

• A 10 minute auto-timer shuts the unit OFF automatically if left ON by accident, to help prevent unwanted battery drain.

• Rubber grip for no-slip handling

• Color coded banana jacks, compatible with most common test leads

• One year limited warranty

Specifications

• Supply voltage: 9V DC

• Input test settings under load: 4.8V DC (4 cell battery)

• 6V DC (5 cell battery)

• 9.6V DC (8 cell battery)

• Optional load current: 250mA each setting

• Maximum voltage measurement: 19.99V DC

• Length: 4.5" (113mm)

• Width: 2�" (67mm)

• Height: 1" (25.4mm)

• Weight: 4.7oz (136g)

• Auto-off timer: Shuts OFF after 10 minutes

• Low battery indicator: Battery symbol in LCD window

Contents

• One Digital Voltmeter MkIII with pre-installed 9V battery

• One Instruction Sheet

Requirements

• Test or charge leads with banana plugs such as the Hobbico pre-assembled test and charge leads (HCAP0101 HCAP0110)

• HCAP0101 FUTABA J Tx/Rx CHARGE LEADS (NOT FOR 9VAP)

• HCAP0102 FUTABA J Tx/Rx CHARGE LEADS 9VAP ONLY

• HCAP0105 JR Tx/Rx CHARGE LEADS

• HCAP0106 HITEC/AIRTRONICS Z Tx/Rx CHARGE LEADS

• HCAP0107 CHARGE LEAD GLOW-STARTER - ALL

• HCAP0108 CHARGE LEAD W/ ALLIGATOR CLIP(2)

• HCAP0109 VOLTMETER TEST PROBES (2)

• HCAP0110 CHARGE LEADS 9V Tx PLUG and FUT J Rx

Comments

• The modeler may purchase the preceding pre-made Rx and Tx connectors: However, you CANNOT test diode-protected Tx packs with voltmeters through the radio charge jack. The pack MUST BE REMOVED from the transmitter to get an accurate voltage reading.

• Modelers can make their own connectors by purchasing one HCAP0310 Banana Plugs, 16 Gauge Wire, and their radio connector