O.S. 38000 GT55 Gasoline Engine 54.9cc/3.352ci
This is the O.S. GT55 Gasoline Engine with Electronic Ignition.
Features
O.S. 38000 GT55 Gasoline Engine 54.9cc/3.352ci
IG-01 Capacitive Discharge Ignition uses a microcomputer programmed for optimum spark advance through the use of magnetic sensors on the crankcase and prop drive, the IG-01 also detects and compensates for wet plugs to ensure consistent quick starts, also requires minimum current in stand-by mode and features a low voltage warning (intermittent engine operation)
Front mounted carburetor stays cooler for less heat percolation and more consistent performance, simple and direct throttle and choke linkages
Unique one-piece crankcase eliminates gaskets and enhances strength and precision
Front induction rotary valve crankshaft design for positive opening and closing of valve for optimum timing, no oil seal required which eliminates RPM loss due to additional friction
Massive front and rear crankshaft bearings for longer life and maximum power output
Thin high-performance piston ring and high-strength aluminum alloy piston for reduced break-in and high compression from the very first run
Two year limited warranty beginning at date of purchase
Specifications
Displacement: 54.9cc (3.35 ci)
Bore: 1.62" (41.2mm)
Stroke: 1.62" (41.2mm)
Practical RPM: 1,800 - 8,000
Weight: Engine 1,580g (3.48lbs)
Igniter 140g (4.9oz)
Carburetor Settings: Two turns out on high and low speed needles from fully closed position, then start engine and follow break-in instructions on pages 24-25 in manual
Distance/center of Mounting Standoff Holes Top to Bottom: 2.6" (66mm)
Distance/center of Mounting Standoff Holes Side to Side: 3.1" (78mm)
Distance/center/Mounting Standoff Holes/Crankshaft Center:1.3" (33mm)
Height/bottom of Mount to Top of Cylinder Head: 7.1" (180.4mm)
Height/center of Crankshaft to Top of Cylinder Head: 5.5" (139.2mm)
Width at Cylinder Head: 2.9" (75mm)
Center of Crankshaft to Center of Exhaust Outlet: 2.9" (74.6mm)
Length from Mount to End of Drive Spacer: 5.9" (150mm)
Length from Mount to Crankcase Center: 1.5" (37.5mm)
Package Contents
O.S. GT55 Gasoline Engine with Electronic Ignition, Carburetor, CM-6 Spark Plug, four Mounting Standoffs, Prop Washer with four 5x40mm Socket Head Cap Screws and Instruction Manual
Requirements
Propeller: 22x8 for break-in 22x10, 23x8, 23x10, 24x8, 24x10 for sport/acro/scale use
Two-Cycle Oil: Klotz Modelube recommended, mix at 50:1 ratio
Muffler: See COMMENTS below
Fuel: Unleaded regular gasoline (no need to use high octane)
Comments
The J'TEC Large Wraparound Pitts Muffler, JTCG7950 will fit this engine for inverted mounting applications.
The Slimline #2123 and #2123S mufflers and the Bisson #9250 (wraparound) and #9251 (inverted) mufflers will also fit but are not carried by us.
"What else can I say, but this Magic Cars Hummer is awesome. Bought it for my 1 year old son and he loves it." ... read more